Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set, except DTC P1089, related to the following system/component: Fuel System
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the following aftermarket equipment/accessories are not installed:
- B75 Mass Air Flow Sensor
- Calibration/Software
- Exhaust System
- Intake Air Duct
- If aftermarket equipment/accessories are installed
Repair or replace as necessary
- Go to next step: If aftermarket equipment/accessories are not installed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.