Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Exhaust Aftertreatment System Description

Circuit	Description
Control - Terminal 1	The output circuit is switched to ground to activate the component.
Control - Terminal 2	The output circuit is switched to 12 V to activate the component.

Component	Description
K20 Engine Control Module	The reductant injector is used to dose and atomize the reductant into the exhaust system. The control module contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.
Q61 Reductant Injector	The reductant injector is used to dose and atomize the reductant into the exhaust system.

Component

Description

K20 Engine Control Module

The reductant injector is used to dose and atomize the reductant into the exhaust system.
The control module contains a microprocessor used to process input data to control outputs.
The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.

Q61 Reductant Injector

The reductant injector is used to dose and atomize the reductant into the exhaust system.