Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC U063F is not set.
- If DTC U063F is set
- Go to next step: If DTC U063F is not set
- Verify there are no DTCs set related to the following component/system:
- B9 Ambient Air Temperature Sensor
- B34 Engine Coolant Temperature Sensor
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Clear the DTCs.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Replace the component: Q97M Engine Coolant Flow Control Valve - Main
- Go to next step: If no DTC is set
- If the DTC sets
- All OK.