Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: E12 Glow Plug
- Ignition - On / Vehicle - In Service Mode
- Connect a test lamp between the test points: Control circuit terminal 1/A & Ground
- Perform the scan tool control function: Glow Plugs - On and Off
Verify the test lamp turns On and Off.
- If the test lamp is always Off
- Ignition/Vehicle - Off & Remove - Test lamp
- Disconnect the electrical connector: X1 @ K20 Engine Control Module
- Test for infinite resistance between the test points: Control circuit terminal 1/A @ Component harness & Ground
- If less than infinite resistance - Repair the short to ground on the circuit.
- Go to next step: If infinite resistance
- Test for less than 2 ohms between the test points: Control circuit terminal 1/A @ Component harness & The other end of the circuit @ Control module harness
- If 2 ohms or greater - Repair the open/high resistance in the circuit.
- If less than 2 ohms - Replace the component: K20 Engine Control Module
- If the test lamp is always On
- Ignition/Vehicle - Off & Remove - Test lamp
- Disconnect the electrical connector: X1 @ K20 Engine Control Module
- Ignition - On / Vehicle - In Service Mode
- Test for less than 1 V between the test points: Control circuit terminal 1/A @ Component harness & Ground
- If 1 V or greater - Repair the short to voltage on the circuit.
- If less than 1 V - Replace the component: K20 Engine Control Module
- Go to next step: If the test lamp turns On and Off
- Test or replace the component: E12 Glow Plug
NOTE:
The scan tool control function may turn off after 3 s.