Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: B130C Exhaust Gas Recirculation Temperature Sensor 3
- Test the resistance between the test points: Terminal 1 & Terminal 2 @ Component
- Verify the value is within the range listed in the table: Temperature Versus Resistance (B131A Exhaust Temperature Sensor 1)
, or Temperature Versus Resistance (B130B Exhaust Gas Recirculation Temperature Sensor 2)
, or Temperature Versus Resistance (B130A Exhaust Gas Recirculation Temperature Sensor and B131B, B131C Exhaust Temperature Sensor 2, 3)
- If not in the specified range
Replace the component: B130C Exhaust Gas Recirculation Temperature Sensor 3
- Go to next step: If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: B130C Exhaust Gas Recirculation Temperature Sensor 3
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.