Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P066A - P066F, P0671 - P0676, or P067A - P067f is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Replace the component: K20 Engine Control Module
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.