Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Verify the tool is available: CH-51450-A Oscilloscope Diagnostic Kit & CH-51450-LEAD-A Oscilloscope Basic Lead Kit
- If the tool is not available
Refer to step 4
- Go to next step: If the tool is available
- If the tool is not available
- Perform the following procedure/test: Relative Engine Compression Test
Verify the procedure/test passes.
- If the procedure/test does not pass
Refer to: Symptoms - Engine Mechanical
- Go to next step: If the procedure/test passes
- If the procedure/test does not pass
- Verify the following conditions do not exist:
- Q17 Fuel Injector - Incorrect connection/Leaking/Loose/Visible Damage
- Fuel - Fill Level = Low
- Fuel Line (All) - Blocked/Incorrect connection/Kinked/Leaking/Loose/Visible Damage
- If a condition exists
Repair or replace as necessary
- Go to next step: If no conditions exist
- Perform the following procedure/test: Fuel System Diagnosis
- If the procedure/test does not pass
Repair or replace as necessary
- Go to next step: If the procedure/test passes
- If the procedure/test does not pass
- All OK.