LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (1 Of 5)) >> Diagnostic Information and Procedures >> DTC P017B-P017D, P117F, P14C0, or P2C3A-P2C3D >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: B96 Cylinder Head Temperature Sensor
  3. Test the resistance between the test points: - One at a time
    • Signal circuit terminal 2 & Low Reference circuit terminal 1 @ Component
    • Signal circuit terminal 3 & Low Reference circuit terminal 1 @ Component
  4. Verify the value is within the range listed in the table: Temperature Versus Resistance (B131A Exhaust Temperature Sensor 1) , or Temperature Versus Resistance (B130B Exhaust Gas Recirculation Temperature Sensor 2) , or Temperature Versus Resistance (B130A Exhaust Gas Recirculation Temperature Sensor and B131B, B131C Exhaust Temperature Sensor 2, 3)
    • If not in the specified range 

      Replace the appropriate component: B96 Cylinder Head Temperature Sensor

    • Go to next step: If in the specified range 
  5. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the appropriate component: B96 Cylinder Head Temperature Sensor

    • Go to next step: If infinite resistance 
  6. All OK.
scientia non olet · About LEMON Manuals