Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P0106, P0107, P0108, P2227, P2228, P2229, P2230, P227B, P227C, P227D, P227E is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify the following conditions do not exist:
- Q20 Intake Air Flow Valve - Loose Clamps / Visible Damage
- Air Cleaner Element - Dirty / Restricted
- Intake Air Duct & Intake Manifold - Cracked / Loose Clamps / Visible Damage
- B75 Mass Air Flow Sensor - Cracked / Loose Clamps / Visible Damage
- Air Inlet Valve - Barometric Pressure Sensor @ K20 Engine Control Module / Leaking / Missing / Clogged /Visible Damage
- O-Ring @ B65 Intake Manifold Pressure and Air Temperature Sensor / Leaking / Missing / Visible Damage
- Positive Crankcase Ventilation System - Leaking / Incorrect connection / Restricted
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Verify the scan tool parameter:
- Barometric Pressure Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- Barometric Pressure Sensor 2 = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- Manifold Absolute Pressure Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- If not in the specified range
- { Barometric Pressure Sensor } Refer to: DTC P2227-P2230
- { Barometric Pressure Sensor 2 } Refer to: DTC P227B-P227E
- { Manifold Absolute Pressure Sensor} Refer to: DTC P0106, P0107, or P0108
- Go to next step: If in the specified range
- All OK.