Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE:

If you were sent here from DTC P026A - Refer to: Circuit/System Testing.

Ignition - On / Vehicle - In Service Mode
Verify the scan tool parameter:
- { B193A } Charge Air Cooler Temperature Sensor = -39 to 215°C (-38 to 419°F)
- { B193B } Charge Air Cooler Temperature Sensor 2 = -39 to 215°C (-38 to 419°F)
- If not between -39 and 215°C (-38 and 419°F)
  Refer to: Circuit/System Testing
- Go to next step: If between -39 and 215°C (-38 and 419°F)
Verify the scan tool parameter:
- Charge Air Cooler Temperature Sensor = The parameter value should not change
- Charge Air Cooler Temperature Sensor 2 = The parameter value should not change
- Perform the action while monitoring the parameter:
- Wiggle the harness and connector: B193A Charge Air Cooler Air Temperature Sensor - Inlet
- Wiggle the harness and connector: B193B Charge Air Cooler Air Temperature Sensor - Outlet
- Wiggle the harness and connector: K20 Engine Control Module
- If the parameter value changes
  Repair as necessary - Wiring / Terminal (s) / Electrical Connector (s)
- Go to next step: If the parameter value does not change
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.