Installation Procedure
Brake System Control Module (1) - Install
- Electronic Brake Control Module Bolt (2) - Install NEW and tighten in sequence [6x] - Fastener Specifications
Electrical Connector (1) @ Brake System Control Module - Connect
- Front Wheelhouse Liner - Install - Front Wheelhouse Liner Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Reprogram the brake system control module. Control Module References
CAUTION:
Refer to Fastener Caution .