Removal Procedure
Rear Bumper Fascia (1) - Remove - Rear Bumper Fascia Removal and Installation
- Disconnect all electrical connectors.
- Remove the wiring harness.
Rear Bumper Fascia Molding Retainer (1) - Remove [4x]
- Using the appropriate tool, release the rear bumper fascia lower molding (2).
Turn the 2 rear bumper fascia trailer hitch cover retainer (1) 1/4 turn counter clockwise and remove.
- Rear Bumper Fascia Trailer Hitch Cover (2) - Remove
If equipped, release the 3 retainer tabs and remove the low frequency rear bumper antenna (1).
Remove the left and right side object sensing module bolt (1).
- Remove the left and right side object sensing alert module (2).
- NOTE:
The object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.
- Lift the locking tabs on the housing and remove the 4 parking assist alarm sensors (1).
Disengage the wire at the connector, disengage opposite end, then pull back on each tab, and apply slight force on rear closure hands fee sensor (1) push the sensor out of the tabs.
Rear Closure Hands Free Module Bolt (1) - Remove
- Rear Closure Hands Free Module (2) - Remove
Rear Closure Hands Free Module Bolt (1) - Remove [2x]
- Rear Closure Hands Free Lamp (2) - Remove
Rear Closure Hands Free Module Bolt (1) - Remove [2x]
- Rear Closure Hands Free Module Retainer (2) - Remove [2x]
Rear Closure Hands Free Module Bracket (1) - Remove
Rear Fascia Signal Lamp Bolt (1) - Remove [4x]
Rear Fascia Lower Signal Lamp (1) - Remove [2x]
Rear Bumper Fascia Bolt (1) - Remove [4x]
- Rear Bumper Fascia Retainer (2) - Remove [4x]
- Release the retainer tabs on the rear lower fascia and remove from the rear bumper upper fascia (3).