Removal Procedure
Front Bumper Fascia (2) - Remove - Front Bumper Fascia Removal and Installation (without Front Fascia Extension) , or Front Bumper Fascia Removal and Installation (with Front Fascia Extension)
- Disconnect all electrical connectors.
- Remove the wiring harness.
Front Bumper Fascia Reinforcement Bolt (1) - Remove [6x]
- Remove the left and right side front bumper fascia reinforcements (2).
Front Bumper Fascia Bolt (1) - Remove [10x]
- Front Bumper Fascia Outer Air Duct (2) - Remove
Front Bumper Fascia Bolt (1) - Remove [5x]
- Front Bumper Fascia Seal (2) - Remove
Remove the 4 left and right side front side marker lamp retainers (2).
- Remove the left and right side front side marker lamps (3).
- NOTE:
The object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.
- Lift the locking tabs on the housing and remove the 4 parking assist alarm sensors (1).
Release the clips with a suitable tool.
- Release the retaining tabs.
- Front Grille (1) - Remove
Front Grille Clip (1) - Remove [8x]
- Release the retainers and remove the front lower grille (2).
Release the tabs on the lower fascia and carefully remove the front bumper upper fascia (1) from the front bumper lower fascia.