Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Bumper Shutter (2) - Install

CAUTION:

Refer to Fastener Caution .

Front Bumper Shutter Bolt (1) - Install and tighten [9x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Shutter Retainer (1) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors and install wiring harness.
Install the left and right side outer front bumper shutter retainer (1).
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector. (2)
Ambient Air Temperature Sensor (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Upper Stiffener (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Install and tighten the left and right side front bumper fascia upper stiffener bolt (2). Fastener Specifications
Tighten the left and right side front bumper fascia upper stiffener nut (1). Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown right side similar.

Connect all electrical connectors.
Secure the wiring harness retaining tab.
Install the right and left side headlamps (2).
Secure the front headlamp guide pin to the front bumper fascia guide (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown right side similar.

Install the 6 right and left side headlamp bolts (1). Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown right side similar.

Install the 6 right and left side headlamp bolts (1). Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia (2) - Install - Front Bumper Fascia Removal and Installation (without Front Fascia Extension) , or Front Bumper Fascia Removal and Installation (with Front Fascia Extension)