Removal Procedure
Front Bumper Fascia (1) - Remove - Front Bumper Fascia Removal and Installation (without Front Fascia Extension) , or Front Bumper Fascia Removal and Installation (with Front Fascia Extension)
Headlamp Bolt (1) - Remove [6x]
Headlamp Bolt (1) - Remove [6x]
Release the front headlamp guide pin from the front bumper fascia guide (1).
- Front Headlamp (2) - Remove [2x]
- Release the wiring harness retaining tab.
- Disconnect all electrical connectors.
Loosen the left and right side front bumper fascia upper stiffener nut (1).
- Remove the left and right side front bumper fascia upper stiffener bolt (2).
Pull the front bumper fascia upper stiffener (1) up and out over the stud.
{If equipped} Forward Range Radar Bracket Bolt (1) - Remove [4x]
- {If equipped} Forward Range Radar Bracket (2) - Remove
- {If equipped} Disconnect the electrical connector.
Reposition the wiring harness.
- Front Bumper Impact Bar Bolt (1) - Remove [6x]
- Front Bumper Impact Bar (2) - Remove
NOTE:
Forward range radar sensor will be with the bracket.