Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Verify there are no related DTCs set in the following system: Active Grille Air Shutter
- If a related DTC is not set
- Go to next step: If a related DTC is set
- Verify the component location is free of debris, clutter or any obstruction that may reduce airflow which could cause an overheat condition: Active Grille Air Shutter
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Verify that no DTC listed in the DTC Descriptor Category is set.
- If a related DTC is set
Refer to Circuit/System Testing.
- Go to next step: If a related DTC is not set
- If a related DTC is set
- All OK.