LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Riser Inner Finish Cover Replacement - Inboard (Bucket) >> Removal Procedure

Removal Procedure

  1. GM5599034Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  2. Rear Seat Riser Finish Cover (1) - Remove
  3. GM5605358Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Using a flat-bladed plastic trim tool, release the retaining clip.

  4. Rear Seat Riser Finish Cover (1) - Remove
  5. GM5599036Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  6. Using a suitable plastic trim tool, release the retaining tabs.
  7. Rear Seat Riser Inner Finish Cover-Inboard (1) - Remove
scientia non olet · About LEMON Manuals