Removal Procedure
Rear Seat Cushion Cover and Pad (1) Remove - Rear Seat Cushion Cover and Pad Removal and Installation (Bucket) , or Rear Seat Cushion Cover and Pad Removal and Installation (40 Percent)
Depress the retaining tab while pulling the rear seat hinge finish cover (1) inward then upward to release from the rear seat hinge.
- Rear Seat Hinge Finish Cover-Outboard (1) - Remove
Rear Seat Riser Finish Cover Retainer (1) - Remove
- Rear Seat Back Cover Retainer (2) - Remove
- Rear Seat Recliner Inner Finish Cover (3) - Remove
Place the rear seat in the fold and tumble position.
- Release the wiring harness retainers as necessary.
- Front Seat Bolt (1) - Remove [2x]
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Seat Track Finish Cover (2) - Remove
- NOTE:
- Note the location and routing of the seat cable to ensure proper installation.
- Quantity of retainers may vary based on option content.
Using a suitable tool, release the seat cable retaining features.
- Release the cable ends from the seat frame.
- Return the rear seat to the original position.
- Rear Seat Cable Tie (1) - Remove and DISCARD [3x]
- Rear Seat Latch Cable-Track Release Easy Entry (2) - Remove