LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Latch Cable Replacement - Track Release Comfort Adjustment (40 Percent, Bucket) >> Removal Procedure

Removal Procedure

  1. GM5606266Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Cushion Cover and Pad (1) Remove - Rear Seat Cushion Cover and Pad Removal and Installation (Bucket) , or Rear Seat Cushion Cover and Pad Removal and Installation (40 Percent) 

  2. GM5600940Courtesy of GENERAL MOTORS COMPANY

    Place the rear seat in the fold and tumble position.

  3. Release the wiring harness retainers as necessary.
  4. Front Seat Bolt (1) - Remove [2x]
  5. Using a flat-bladed plastic trim tool, release the retaining clips.
  6. Rear Seat Track Finish Cover (2) - Remove
  7. GM5607642Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Note the location and routing of the seat cable to ensure proper installation.
    • Quantity of retainers may vary based on option content.

    Using a suitable tool, release the seat cable retaining features.

  8. Release the cable end from the seat frame.
  9. Return the rear seat to the original position.
  10. Rear Seat Bolt (1) - Remove [2x]
  11. Rear Seat Cable Tie (2) - Remove and DISCARD
  12. Rear Seat Latch Cable-Track Release Comfort Adjustment (3) - Remove
scientia non olet · About LEMON Manuals