Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Reposition the seat as necessary.
Using a suitable plastic trim tool, release the two rear seat anchor plate bezel plastic retainers.
Rear Seat Anchor Plate Bezel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Unzip the left and right rear seat back cover zippers.
Reposition the rear seat back cover, pad, J-channel retainers, and retainers as necessary.
Using a suitable flat-bladed tool, open the rear seat head restraint cable cover (1).
Release the rear seat head restraint cable (2).
Courtesy of GENERAL MOTORS COMPANY

Twist the rear seat head restraint guide bezels (1) counter clockwise while lifting the bezels upward onto the head restraint adjuster rod.
Using a suitable pointed or flat bladed tool, push the rear seat head restraint guide clip (2) rearward while pulling upward on the rear seat head restraint (3).
Rear Seat Head Restraint (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Using a suitable flat-bladed tool, push the plastic tab of the rear seat head restraint guide (1) inward and pull upward to remove from the seat back frame.