LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Frame Replacement (60 Percent) >> Removal Procedure

Removal Procedure

  1. GM5608390Courtesy of GENERAL MOTORS COMPANY

    Rear Seat (2) - Remove - Rear Seat Removal and Installation (60 Percent) 

  2. GM5608398Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Cushion Cover and Pad (1) - Remove - Rear Seat Cushion Cover and Pad Removal and Installation (60 Percent) 

  3. GM5608400Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Back Cover and Pad (1) - Remove - Rear Seat Back Cover and Pad Removal and Installation (60 Percent) 

  4. GM5609531Courtesy of GENERAL MOTORS COMPANY

    Using a suitable flat-bladed tool, push the plastic tab of the rear seat head restraint guide (1) inward and pull upward to remove from the seat back frame.

  5. Rear Seat Head Restraint Guide (1) - Remove [2x]
  6. GM5609547Courtesy of GENERAL MOTORS COMPANY

    Using a suitable trim tool, release the retainers.

  7. Rear Seat Back Opening Finish Cover Retainer (1) - Remove [2x]
  8. Rear Seat Belt Guide Trim Cover (2) - Remove
  9. Feed the rear seat center belt through the rear seat belt guide trim cover (2).
  10. GM5609539Courtesy of GENERAL MOTORS COMPANY

    Using a suitable trim tool, release the retainers.

  11. Rear Seat Back Cover Retainer (1) - Remove [12x]
  12. Rear Seat Back Panel (2) - Remove
  13. GM5609542Courtesy of GENERAL MOTORS COMPANY

    Rear Center Seat Belt Buckle Bolt (1) - Remove

  14. Feed the rear seat center belt through the rear seat frame.
  15. Rear Seat Center Belt Retractor (2) - Remove
  16. GM5608412Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Disconnect and reposition harness as necessary.

  17. Rear Seat Belt Buckle Bolt (1) - Remove
  18. Rear Seat Belt Buckle (2) - Remove
  19. GM5608773Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Disconnect and reposition harness as necessary.

  20. Rear Seat Belt Buckle (1) - Remove
  21. GM5608392Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Riser Finish Cover Retainer (1) - Remove

  22. Using a flat-bladed plastic trim tool, release the retaining clips.
  23. Rear Seat Riser Finish Cover (2) - Remove
  24. GM5605358Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Left side shown, right side similar.

    Using a flat-bladed plastic trim tool, release the retaining clip.

  25. Rear Seat Riser Finish Cover (1) - Remove [2x]
  26. GM5599035Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  27. Using a suitable plastic trim tool, release the retaining tabs.
  28. Rear Seat Riser Inner Finish Cover-Outboard (1) - Remove
  29. GM5608393Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  30. Using a suitable plastic trim tool, release the retaining tabs.
  31. Rear Seat Riser Inner Finish Cover-Inboard (1) - Remove
  32. GM5605359Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Latch Finish Cover (1) - Remove [2x]

  33. GM5608397Courtesy of GENERAL MOTORS COMPANY

    Release the remaining J-channel retainers on the rear seat cushion trim panel (2).

  34. Rear Seat Back Opening Finish Cover Retainer (1) - Remove [4x]
  35. GM5609524Courtesy of GENERAL MOTORS COMPANY

    Place the rear seat in the fold and tumble position.

  36. Rear Seat Riser Finish Cover Retainer (1) - Remove [2x]
  37. Rear Seat Cushion Trim Panel (2) - Remove
  38. GM5609521Courtesy of GENERAL MOTORS COMPANY

    Disconnect the wiring harness retainers and reposition the harness as necessary.

  39. Front Seat Bolt (1) - Remove [2x]
  40. Using a flat-bladed plastic trim tool, release the retaining clips.
  41. Rear Seat Track Finish Cover (2) - Remove
  42. GM5606900Courtesy of GENERAL MOTORS COMPANY

    Return the rear seat to the original position.

    43. NOTE:

    Note the location and routing of the seat cable to ensure proper installation.

  43. Release the folding rear seat back actuator cable (2) from the cable retainer (1).
  44. Disconnect the rear seat back actuator cable end from the rear seat frame.
  45. GM5608407Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector.

  46. Rear Seat Riser Bolt (1) - Remove [3x]
  47. Folding Rear Seat Back Actuator (2) - Remove
  48. GM5608409Courtesy of GENERAL MOTORS COMPANY

    Position the seat as necessary to access the seat bolts.

  49. Disconnect the wiring harness retainers and reposition the harness as necessary.
  50. Front Seat Bolt (1) - Remove [4x]
  51. Rear Seat Heater Control Module Bracket (2) - Remove
  52. GM5605755Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  53. Rear Seat Frame Rear Finish Cover (2) - Remove [2x]
  54. GM5605753Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Riser Finish Cover Retainer (1) - Remove

  55. Rear Seat Back Cover Retainer (2) - Remove
  56. Rear Seat Recliner Inner Finish Cover (3) - Remove
  57. GM5605754Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Riser Finish Cover Retainer (1) - Remove

  58. Rear Seat Back Cover Retainer (2) - Remove
  59. Rear Seat Recliner Inner Finish Cover (3) - Remove
  60. GM5605356Courtesy of GENERAL MOTORS COMPANY

    Depress the retaining tab while pulling the rear seat hinge finish cover (1) inward then upward to release from the rear seat hinge.

  61. Rear Seat Hinge Finish Cover-Outboard (1) - Remove
  62. GM5608395Courtesy of GENERAL MOTORS COMPANY

    Depress the retaining tab while pulling the rear seat hinge finish cover (1) inward then upward to release from the rear seat hinge.

  63. Rear Seat Hinge Finish Cover-Inboard (1) - Remove
  64. GM5608405Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical wiring harness shown, individual harness may be different due to option content. Various seat components may need to be removed from the seat to access the harness depending on seat and content options.

    Disconnect the electrical connectors and release the wiring harness retainers as necessary.

  65. Rear Seat Wiring Harness (1) - Remove
  66. GM5611920Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Frame (1) - Remove

scientia non olet · About LEMON Manuals