Removal Procedure
Rear Seat Riser Finish Cover Retainer (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Seat Riser Finish Cover (2) - Remove
Place the opposite rear seat in the fold and tumble position.
- Using a flat-bladed plastic trim tool, release the retaining clip.
- Rear Seat Riser Finish Cover (1) - Remove [2x]
Using a flat-bladed plastic trim tool, release the retaining clips.
- Using a suitable plastic trim tool, release the retaining tabs.
- Rear Seat Riser Inner Finish Cover-Outboard (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Using a suitable plastic trim tool, release the retaining tabs.
- Rear Seat Riser Inner Finish Cover-Inboard (1) - Remove
Rear Seat Riser Finish Cover Retainer (1) - Remove [2x]
- Release the J-channel retainers from the rear seat cushion cover and rear seat cushion trim panel (2).
Release the remaining J-channel retainers on the rear seat cushion trim panel (2).
- Rear Seat Back Opening Finish Cover Retainer (1) - Remove [4x]
Place the rear seat in the fold and tumble position.
- Rear Seat Riser Finish Cover Retainer (1) - Remove [2x]
- Rear Seat Cushion Trim Panel (2) - Remove