Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Seat Cushion Cover and Pad (1) - Remove - Rear Seat Cushion Cover and Pad Removal and Installation (60 Percent)
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Riser Finish Cover Retainer (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Rear Seat Riser Finish Cover (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clip.
Rear Seat Riser Finish Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Using a suitable plastic trim tool, release the retaining tabs.
Rear Seat Riser Inner Finish Cover-Outboard (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Latch Finish Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Note the location and routing of the seat cable to ensure proper installation.
- Quantity of retainers may vary based on option content.
Rear Seat Cable Tie (1) - Remove and DISCARD
Using a suitable tool, release the seat cable retaining features.
Release the cable ends from the seat frame.
Rear Seat Back Latch Cable-Outboard Floor Latch (2) - Remove