LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Latch Cable Replacement - Outboard (40 Percent, Bucket) >> Removal Procedure

Removal Procedure

  1. GM5606266Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Cushion Cover and Pad (1) - Remove - Rear Seat Cushion Cover and Pad Removal and Installation (Bucket) , or Rear Seat Cushion Cover and Pad Removal and Installation (40 Percent) 

  2. GM5599034Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  3. Rear Seat Riser Finish Cover (1) - Remove
  4. GM5605358Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clip.

  5. Rear Seat Riser Finish Cover (1) - Remove
  6. GM5599035Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  7. Using a suitable plastic trim tool, release the retaining tabs.
  8. Rear Seat Riser Inner Finish Cover-Outboard (1) - Remove
  9. GM5605359Courtesy of GENERAL MOTORS COMPANY

    Rear Seat Latch Finish Cover (1) - Remove

  10. GM5607640Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Note the location and routing of the seat cable to ensure proper installation.

    Rear Seat Cable Tie (1) - Remove and DISCARD

  11. Using a suitable tool, release the seat cable retaining features.
  12. Release the cable ends from the seat frame.
  13. Rear Seat Back Latch Cable-Outboard Floor Latch (2) - Remove
scientia non olet · About LEMON Manuals