Removal Procedure
Front Center Seat (3) - Remove - Front Center Seat Removal and Installation
Using a suitable plastic trim tool, release the retaining clips.
- Front Seat Center Armrest Hinge Finish Cover-Upper (1) - Remove [2x]
Front Seat Center Armrest Pivot Bolt (1) - Remove
- Front Seat Armrest Adjust Retainer Bolt (2) - Remove
- Front Seat Armrest Adjust Retainer (3) - Remove
Using a suitable plastic trim tool, release the front seat center armrest hinge finish cover - lower retaining clips.
- Remove and DISCARD seat belt retaining bushings.
- Front Seat Center Belt Buckle - Remove
- Front Seat Center Belt Anchor Plate - Remove
- Front Seat Center Armrest Hinge Finish Cover-Lower (1) - Remove [2x]
Disconnect the latch release cable.
- Front Seat Center Armrest Bolt (1) - Remove [2x]
- Front Center Seat Armrest (2) - Remove
Front Seat Cushion Center Pad Pivot Bolt (1) - Remove
- Front Seat Cushion Center Pad (2) - Remove
Using a suitable plastic trim tool, release the retaining clips.
- Front Seat Center Armrest Hinge Finish Inner Cover (1) - Remove
Using a suitable plastic trim tool, release the retaining clips.
- Pull upward on the front seat back rear center cover (1) to disengage the lower retainers.
- Disconnect the electrical connectors as necessary.
- Front Seat Back Rear Center Cover (1) - Remove
From the underside of the front center seat, depress the six front seat stowage compartment (1) retaining tabs while lifting the upwards to release the compartment from the seat frame.
- {If equipped} Electrical Connector - Disconnect
- Front Seat Stowage Compartment (1) - Remove
Pull outward on the side of the front seat cushion center cover (1) to release the retaining clips from the seat frame.
- Pull the front seat cushion center cover (1) forward to release the remaining retaining clips.
- Front Seat Cushion Center Cover (1) - Remove
Front Seat Back Latch Bolt (1) - Remove [2x]
- Front Seat Back Latch (2) - Remove
Front Seat Center Storage Compartment Bolt (1) - Remove
- Front Seat Cushion Pad Center Support (2) - Remove
Front Seat Cushion Center Frame (1) - Remove
- Transfer components as necessary.
Seat belt retaining bushings are for manufacturing purposes only.