Removal Procedure
Reposition the seat as necessary.
- Using a suitable plastic trim tool, release the 3rd row seat anchor plate bezel plastic retainers.
- 3rd Row Seat Anchor Plate Bezel-Outboard (1) - Remove
{If equipped} Using a suitable plastic trim tool, release the retaining tabs.
- {If equipped} 3rd Row Seat Back Latch Release Handle Bezel (1) - Remove
- If equipped, feed the 3rd row seat pull strap through the bezel (1) to remove.
- NOTE:
Some components not shown for graphic clarity.
Disengage the J-channel retainers from the seat back frame.
- Unzip the left and right seat back cover zippers.
- Reposition the seat back cover and pad as necessary to access the 3rd row seat head restraint cable (2).
- Using a suitable flat-bladed tool, open the 3rd row seat head restraint cable cover (1).
- Release the 3rd row seat head restraint cable (2).
Using a suitable pointed or flat bladed tool, push the 3rd row seat head restraint guide clip (1) rearward while pulling upward on the 3rd row seat head restraint (2).
- 3rd Row Seat Head Restraint (2) - Remove
- NOTE:
Some components not shown for graphic clarity.
Using a suitable flat-bladed tool, push the plastic tab of the 3rd row seat head restraint guide (1) inward and pull upward to remove from the seat back frame.