Circuit/System Description

The unlatch, primary, and neutral switches are part of the liftgate latch and are used by the rear gate module to determine the state of the latch during the process of cinching or unlatching. The unlatch and primary switches will be inactive when the primary and secondary latches are latched, and the neutral switch will be active during the power cinch function. Each of the latch switch signal circuits are supplied signal through a resistor and monitored within the rear gate module. The latch switches share a common low reference circuit from the rear gate module and when the switch contacts close, the signal circuit goes low and the rear gate module determines the switch to be active.

The rear gate module continuously monitors power liftgate operation and calculates its location and direction of travel using 2 Hall effect sensors that are part of the liftgate motor. The Hall effect sensors are 12 V 3-wire sensors and are supplied with a 12 V reference, ground and signal circuits from the rear gate module. The Hall effect sensor signal circuits are referenced from voltage within the rear gate module and pulsed low by the Hall effect sensors.