Circuit/System Verification
- Ignition ON.
- Operate the component: Open the liftgate.
Verify the scan tool parameter: Rear Gate Ajar = Ajar
- If the parameter value does not change
Refer to: Circuit/System Testing
- Go to next step: If the parameter value changes
- If the parameter value does not change
- Operate the component: Close the liftgate.
Verify the scan tool parameter: Rear Gate Ajar = Closed
- If the parameter value does not change
Refer to: Circuit/System Testing
- Go to next step: If the parameter value changes
- If the parameter value does not change
- All OK.