LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Vehicle Access - Diagnostic Information And Procedures (2 Of 2) >> Diagnostic Information and Procedures >> Liftgate Ajar Indicator Malfunction (TB4) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the A23 Liftgate Latch.
  2. Verify a test lamp illuminates between ground circuit terminal 2 and B+.
    • If the test lamp does not illuminate 
    1. Repair the open/high resistance on circuit 2050 or the ground connection.
    • Go to next step: If the test lamp illuminates 
  3. Ignition ON.
  4. Verify the verify the DIC Rear Access Open message is not displayed
    • If displayed 
    1. Test the circuit 1303 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    2. Replace the K219 Lighting Control Module.
    • Go to next step: If not displayed 
  5. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground.
  6. Verify the DIC Rear Access Open message is displayed.
    • If not displayed and the 3 A fuse is OK 
    1. Test the circuit 1303 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the K219 Lighting Control Module.
    • If not displayed and the 3 A fuse is open 
    1. Test the circuit 1303 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
    2. Replace the K219 Lighting Control Module.
    • Go to next step: If the DIC Rear Access Open message is displayed 
  7. Test or replace the A23 Liftgate Latch.
scientia non olet · About LEMON Manuals