Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Spark ACTIV, Automatic CVT Trans, which is a different variant/trim than selected.

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies To	Note	Standard Hours	Skill Level
All		2.2	B
Front,Both Sides		1.0	B
Rear,Both Sides		1.4	B
Combination Procedure: BRAKE HOSE: Replace:
Each Additional		0.2	B
One	Includes: Perform ABS Automated Bleed procedure.	0.7	B
Combination Procedure: CALIPER: Overhaul:
One	Includes: Perform ABS Automated Bleed procedure.	0.9	B
Combination Procedure: CALIPER: Replace:
One	Includes: Perform ABS Automated Bleed procedure.	0.7	B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
		0.5	B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,Each	Correct Rotor lateral runout by indexing or correction plate.	0.2	B
Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots.
Each Additional		0.3	B
One		0.5	B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,Each	Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.	0.2	B
Combination Procedure: WHEEL BEARING: Replace:
Front,One Side	Includes: R&I Steering Knuckle. DOES NOT include wheel alignment.	1.4	B
Rear,Hub & Bearing Assy,One Side		0.6	B
Combination Procedure: WHEEL CYLINDER: Overhaul:
One,Off Vehicle	Includes: Perform ABS Automated Bleed procedure.	0.9	B
One,On Vehicle	Includes: Perform ABS Automated Bleed procedure.	0.7	B
Combination Procedure: WHEEL CYLINDER: Replace:
One	Includes: Perform ABS Automated Bleed procedure.	0.7	B