LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Spark ACTIV, Standard Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement >> Installation Procedure

Installation Procedure

  1. GM4007609Courtesy of GENERAL MOTORS COMPANY

    Install the brake hose to the brake hose mounting bracket on the rear axle.

  2. Install the brake hose retaining clip (1) onto the hose fitting at the brake hose mounting bracket.
  3. GM4007607Courtesy of GENERAL MOTORS COMPANY

    Install the brake hose to the brake hose mounting bracket on the body frame.

  4. Install the brake hose retaining clip (1) onto the hose fitting at the brake hose mounting bracket.
  5. GM4007581Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Connect the brake pipe fitting (1) to the brake hose at the wheel cylinder side and tighten to 18 N.m (13 lb ft).

  6. GM4007577Courtesy of GENERAL MOTORS COMPANY

    Connect the brake pipe fitting (1) to the brake hose at the rear brake pipe side and tighten to 18 N.m (13 lb ft).

  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , or Hydraulic Brake System Bleeding (Pressure) .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals