Automatic Transmission Case Plug Installation
WARNING: This page is about a different variant/trim than selected.
- Prepare the Automatic Transmission Case Plug (1) for installation as follows:
- Remove all traces of the adhesive patch from the plug and the mating threads using the appropriate tools.
- Clean the threads of the plug and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the plug. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the plug.
- Automatic Transmission Case Plug (1) - Install and tighten [3x] - Fastener Specifications (Off Vehicle) , or Fastener Specifications (On Vehicle)
CAUTION:
Refer to Fastener Caution .