LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Engine Mechanical - 6.2L - Repair Instructions (2 Of 2)) >> Repair Instructions >> Engine Front Cover Cleaning and Inspection >> Single Use Fasteners and Components

Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.
  1. Fig 1: Identifying Engine Front Cover Inspection Points
    GM2889923Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Do not use the crankshaft front oil seal again. Install a NEW crankshaft front oil seal during assembly.
    • Do not use the camshaft position (CMP) actuator magnet gasket again. Install a NEW gasket during assembly.

    Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant

  2. Clean the cover in solvent. Remove the sealant from the cover oil pan surface. Replacing Engine Gaskets
    3. WARNING:

    Refer to Safety Glasses and Compressed Air Warning .

  3. Dry the cover with compressed air.
  4. Inspect the gasket sealing surfaces (1) for excessive scratches or gouging.
  5. Inspect the threaded bolt holes (2, 3, and 5) for damaged threads or debris.
  6. Inspect the camshaft position sensor pass-thru hole and sealing surface (4) for excessive scratches or gouging.
  7. Inspect the oil flow control valve connector pass-thru hole and sealing surface (6) for excessive scratches or gouging.
scientia non olet · About LEMON Manuals