Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
- Cylinder Head Bolt [10x]
- Cylinder Head Gasket
| Callout | Component Name |
|---|---|
| Preliminary Procedure Clean the holes in the block of any debris or residual fastener thread sealant. Failing to do so can cause the bolts not to reach proper torque and/or clamp load. |
|
| 1 | Cylinder Head Gasket
NOTE:
Must use NEW gasket. |
| 2 | Cylinder Head Assembly |
| 3 | Cylinder Head Bolt
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .
NOTE:
The forward most fastener on the Left Side Cylinder Head is unique to all other cylinder head fasteners. It is shorter, has an internal hex drive and has a lower final tightening torque angle. Tighten 80 N.m (59 lb ft) + 90° + 40° |
| 4 | Cylinder Head Bolt Procedure Tighten the cylinder head bolts each pass in the sequence shown. Tighten 80 N.m (59 lb ft) + 90° + 60° |