Clutch Pilot Bearing Installation
WARNING: This page is about a different variant/trim than selected.
Special Tools
- GE-8433 Two Jaw Puller
- EN-45949 Pilot Bearing and Flywheel Locator Installer
Position the bearing to the rear of the crankshaft.
- Assemble the GE-8433
two jaw puller (2), the EN-45949
pilot bearing and flywheel locator installer (1) and bolts to the rear of the crankshaft.
Tighten the bolts until snug.
- Rotate the bolt of the GE-8433 two jaw puller (2) until the bearing is seated in the bore of the crankshaft.
- Remove the tools.
Inspect the clutch pilot bearing for proper installation.