Component Testing
WARNING: This page is about a different variant/trim than selected.
T8 Ignition Coil
- Ignition/Vehicle - Off
- Swap the two components: T8 Ignition Coil - The original component that set the DTC & Another known good component from the vehicle
- Engine - Running
- Verify the scan tool parameter: Cylinder 1 - 8 Current Misfire Counter = Increments - At the original component location the DTC set.
- If the parameter value does not increment
Replace the component: T8 Ignition Coil - The original component that set the DTC
- Go to next step: If the parameter value increments
- If the parameter value does not increment
- Refer to: Circuit/System Testing