Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P2227Condition 1Condition 2
- DTCs related to the following system/component = Not Set
- B65 Intake Manifold Pressure and Air Temperature Sensor
- B107 Accelerator Pedal Position Sensor
- B115 Vehicle Speed Sensor
- B74 Manifold Absolute Pressure Sensor
- B75C Multifunction Intake Air Sensor
- Q38 Throttle Body
- Engine = Running
Condition 3Condition 4
- DTC P2610 = Not set
- DTCs related to the following system/component = Not Set or Pending
- B107 Accelerator Pedal Position Sensor
- B74 Manifold Absolute Pressure Sensor
- Engine = Not Running
- Ignition = On
- Time between current ignition cycle and the last time the engine was running = Greater than 10 s
Frequency the DTC runs = Continuously - After the running conditions are met
P2228, P2229, P2230
Ignition = On
Frequency the DTC runs = Continuously - After the running conditions are met