Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P1516
The following parameters are not within 2% of each other:
- Desired Throttle Position
- Throttle Position
P2101 Condition 1
The following parameters are not within 10% of each other:
- Desired Throttle Position
- Throttle Position
Condition 2
- Throttle Position Learn = Active
- Throttle Position = Greater than 36%
Condition 3
- Throttle Position Learn = Active
- Throttle Position = Greater than 50%
P2119
Blade@Q38 Throttle Body Closed@Engine Off
P2176
Minimum Throttle Position Not Learned = Exceeded Number of Attempts