Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - Crank
- Engine = Cranking
- M64 Starter Motor = Activated - Rotate(s)
- If the component does not work as specified
  Refer to: Starter Malfunction
- Go to next step: If the component works as specified
Ignition - On/Vehicle - In Service Mode
Verify DTC P0562 is not set.
- If the DTC is set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If the DTC is not set
Verify DTC P129D is not set.
- If the DTC is set
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P129D is not set.
- If the DTC is set
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
All OK.