LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Controls And Fuel - 6.2L (LT1/LT4) - Diagnostic Information And Procedures (3 Of 3)) >> Diagnostic Information and Procedures >> DTC P10E1-P10E4 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Fuel System Description

Circuit Description
B+ - Relay Coil Supplied directly from the battery.
Control - Relay Coil The output circuit is switched to ground to activate the component.
Component Description
K20 Engine Control Module The control module contains a microprocessor used to process input data to control outputs.
The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.
KR171 Engine Control Module Wake-Up Relay Relays are used to control a high power circuit with a low power signal.
scientia non olet · About LEMON Manuals