Component Testing
WARNING: This page is about a different variant/trim than selected.
M10 Charge Air Cooler Coolant Pump-Dynamic Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector: M10 Charge Air Cooler Coolant Pump
- Connect a jumper wire between the test points: Ground terminal 4 & Ground
- Connect a jumper wire between the test points: Control terminal 5 & Control terminal 1
- Momentarily connect a 15 A fused jumper wire between the test points: Control terminal 5 & 12 V
Verify the component turns On and Off when connecting and disconnecting the jumper wire: M10 Charge Air Cooler Coolant Pump
- If the component does not turn On and Off
Replace the component: M10 Charge Air Cooler Coolant Pump
- Go to next step: If the component turns On and Off
- If the component does not turn On and Off
- All OK.