Conditions for Running the DTC

P0721, P172A, P172B

• {P077C, P077D} Engine Speed = Greater than 499 RPM
• Battery Voltage = Greater than 9 V
• Ignition = On
• Ignition Voltage = Greater than 9 V
• {P077C, P077D} Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met

P0722, P0723

• {P0722} DTC P0723, P077C, P077D = Not set
• DTCs related to the following system/component = Not Set
  • B14A Transmission Output Shaft Speed Sensor
  • B74 Manifold Absolute Pressure Sensor
  • B75 Mass Air Flow Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• {P0722} Accelerator Pedal Position Sensor = Greater than 3%
• Battery Voltage = Greater than 9 V
• {P0722} Engine Torque = Greater than 30 N.m (22 lb ft)
• Ignition = On
• Ignition Voltage = Greater than 9 V

Frequency the DTC runs = Continuously - After the running conditions are met

P077C, P077D

• {P077C} DTC P077D = Not set
• {P077D} DTC P077C = Not set
• Battery Voltage = Greater than 10 V
• Ignition = On
• Ignition Voltage = Greater than 10 V
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met