Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: Spark Plug Wire@Spark Plug
- Install the special tool: J-26792 Ignition Spark Tester @Spark Plug Wire & Ground
- Engine - Running
- Verify there is spark at the tool.
- If there is no spark
Replace the component: T8 Ignition Coil
- Go to next step: If there is spark
- If there is no spark
- All OK.
NOTE:
Circuit/System Testing must be performed before proceeding with Component Testing.
NOTE:
An erratic or weak spark is considered a no spark condition.