Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter:
- Charge Air Cooler Coolant Pump Relay Control Circuit High Voltage Test Status = OK or Not Run
- Charge Air Cooler Coolant Pump Relay Control Circuit Low Voltage Test Status = OK or Not Run
- Charge Air Cooler Coolant Pump Relay Control Circuit Open Test Status = OK or Not Run
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Perform the scan tool control function: Charge Air Cooler Coolant Pump - On and Off
Verify the component turns On and Off: G36 Auxiliary Heater Coolant Pump
- If the component does not turn On and Off
Refer to: Circuit/System Testing
- Go to next step: If the component turns On and Off
- If the component does not turn On and Off
- All OK.