Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0106, P0107, P0108, P012B, P012C, P010C, P2227, P2228, P2229, P2230 is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = Less than 90%
- If 90% or greater
Refer to: Throttle Body Cleaning
- Go to next step: If less than 90%
- If 90% or greater
- Verify the following conditions do not exist:
- Q38 Throttle Body - Loose Clamps/Visible Damage
- Air Cleaner Element - Dirty/Restricted
- Catalytic Converter - Blocked/Restricted/Visible Damage
- Intake Air Duct & Intake Manifold - Cracked/Loose Clamps/Visible Damage - Refer to: Throttle Body Cleaning
- Mass Airflow Sensor - Cracked/Loose Clamps/Visible Damage
- O-Ring@B65 Intake Manifold Pressure and Air Temperature Sensor/Leaking/Missing/Visible Damage
- O-Ring@B105 Supercharger Inlet Pressure Sensor/Leaking/Missing/Visible Damage
- Positive Crankcase Ventilation System - Leaking/Incorrect connection/Restricted
- Vacuum Hoses - Kinked/Leaking/Incorrect connection/Restricted
- Vacuum leak@Engine/Intake Manifold/Q38 Throttle Body
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Verify the scan tool parameter:
- BARO Sensor = The value should be within the range listed in the table: Altitude Versus Barometric Pressure
- MAP Sensor = The value should be within the range listed in the table: Altitude Versus Barometric Pressure
- Supercharger Inlet Pressure = The value should be within the range listed in the table: Altitude Versus Barometric Pressure
- If not in the specified range
- {BARO Sensor} Refer to: DTC P2227-P2230
- {MAP Sensor} Refer to: DTC P0107 or P0108 (LT4)
- {Supercharger Inlet Pressure Sensor} Refer to: DTC P012C or P012D (LT4)
- Go to next step: If in the specified range
- All OK.