LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 6.2L (LT1/LT4) - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P0090-P0092, P00C8, P00C9, P00CA, or P163A >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:
    • As little as 2 ohms of resistance in a circuit may cause a DTC to set.
    • The component's temperature should be 19 to 21°C (66 to 70°F) while testing.
  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: G18 High Pressure Fuel Pump
  3. Test for 1 to 3 ohms between the test points: Control terminal 1 & Control terminal 2
    • If not between 1 and 3 ohms 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If between 1 and 3 ohms 
  4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals