Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0089, P228C, P228D
- DTC P0016, P0017, P0018, P0019, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0116, P0117, P0118, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P0628, P1682 = Not set
- BARO = Greater than 70 kPa (10.2 PSI)
- Engine = Not cranking
- Fuel Pressure Sensor = Greater than 180 kPa (26 PSI)
- Fuel Temperature = -12 to 132°C (10 to 270°F)
- IAT Sensor 1 = Warmer than -20°C (-4°F)
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P00C6
- DTC P0010, P0011, P0016, P0089, P0090, P0091, P0092, P0096, P0097, P0098, P0099, P00C8, P00C9, P00CA, P0117, P0118, P0178, P0179, P018B, P018C, P018D, P0191, P0192, P0193, P0231, P0232, P023F, P0335, P0336, P0340, P0341, P1682 = Not set
- BARO = Greater than 70 kPa (10.2 PSI)
- ECT Sensor = -100 to 132°C (-148 to 270°F)
- Engine = Not cranking
- Fuel Pressure Sensor = Greater than 0 kPa (0 PSI)
- IAT Sensor 1 = Warmer than -20°C (-4°F)
Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met
P2C1E, P2C1F, P2C20
- BARO = Greater than 70 kPa (10.2 PSI)
- Engine = Not cranking
- Fuel Pressure Sensor = Greater than 180 kPa (26 PSI)
- Fuel Temperature = -12 to 132°C (10 to 270°F)
- IAT Sensor 1 = Warmer than -20°C (-4°F)
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met