LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 6.2L (LT1/LT4) - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P0089, P00C6, P228C, P228D, or P2C1E-P2C20 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    The component's temperature should be 19 to 21°C (66 to 70°F) while testing.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: G18 High Pressure Fuel Pump
  3. Test for 0.90 to 1.4 ohms between the test points: Control terminal 1 & Control terminal 2
    • If not between 0.90 and 1.4 ohms 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If between 0.90 and 1.4 ohms 
  4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals