Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0030, P0031, P0032, P0036, P0037, P0038, P0050, P0051, P0052, P0056, P0057, P0058
- Ignition On - Engine Running
- Engine Speed = Greater than 400 RPM
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0053, P0054, P0059, P0060
- DTC P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0128, P111E, P262B = Not set
- Engine Run Time = For greater than 1 s
- Ignition Off Time = For greater than 8 h
- Ignition Voltage = Less than 32 V
- Start-Up ECT = Greater than -30°C (-22°F)
- Start-Up ECT & Start-Up IAT = Within 8°C (14°F) of each other
Frequency the DTC runs = Once - Per cold start-up - After the running conditions are met
P0135, P0141
- Heated Oxygen Sensor = At normal operating temperature.
- HO2S Heater = Inactive
- Ignition Voltage = Greater than 10 V
Frequency the DTC runs = Once - After the running conditions are met - For greater than 120 s - 2 Attempts per drive cycle
P0155, P0161
- Heated Oxygen Sensor = At normal operating temperature.
- HO2S Heater = Inactive
- Ignition Voltage = Greater than 10 V
Frequency the DTC runs = Once - After the running conditions are met - For greater than 120 s