Filling Procedure
WARNING: This page is about a different variant/trim than selected.
Clean away all dirt and debris from the transmission fluid fill plug area.
- Remove the transmission fluid fill plug (1).
- Fill the transmission with transmission fluid, until even with the bottom of the fill plug hole. Adhesives, Fluids, Lubricants, and Sealers (M13)
- Install the transmission fluid fill plug and tighten to 27 N.m (20 lb ft).
- Run the engine in the Neutral position at 2800 RPM's for 2 minutes to allow the fluid to recirculate.
- Turn the engine Off.
- Allow a dwell time of 10 minutes for the fluid level to return to the oil sump.
- Remove the fill plug and verify the fluid is even with the bottom of fill plug hole. Add or remove fluid as necessary.
- Install the transmission fluid fill plug and tighten to 27 N.m (20 lb ft).
- Remove the drain pan.
- Lower the vehicle.
NOTE:
Ensure the clutch pedal is NOT depressed.